HelioSprint BC+ and HelioXtreme 32+ are supplied
"+"-Engraving heads offer 20% faster engraving at angle 4
The high-performance engraving heads HelioSprint BC and HelioXtreme 32 are getting an upgrade, which speeds up engraving at angle 4 up to 9 khz. Previously supplied engraving systems will be upgraded free of charge!
HELL is now supplying HelioSprint BC and HelioXtreme 32 engraving systems with the suffix “+” as standard. This suffix indicates that these engraving systems engrave at 9 kHz with angle 4 and thus offer 20% better performance than before. To benefit from the higher engraving speed, the HelioKlischograph software needs to be upgraded – see below. An older version of the engraving system software means that „+“-engraving systems continue to engrave at 7.5 kHz with angle 4.
Previously supplied HelioSprint BC and HelioXtreme 32 engraving systems will be upgraded to the higher engraving speed free of charge as part of regular engraving head service.
Software requirements
To benefit from the enhanced performance, the following software is required on the HelioKlischograph:
K500 NT / K500 G3 / K500 G4: HelioControl V 5.0 and later
K5 / K5 Smart: HelioControl V 4.0 and later

Previously supplied engraving systems will be upgraded free of charge as part of regular engraving head service